Using the mechanical design and fabricating skills of Jeff, KC9JOB, along with my electronics design, we have built an array of products over the past 10 years together:
Tilt-Over tower project:
A 30 foot Rohn 45g “raising fixture” allowing us to tilt the big tower. All motorized.
RetroRig” Remote Radio Head Projects
FlexRadio network
I can operate my radios in North Carolina from Wisconsin and my radios in Wisconsin from North Carolina.
MORCONI Remote Keyer Projects
Winkeyer / Morconi Mod project
Megacycle Radio Monitor Project
8 Channel WIFI Relay Controller Project
RF Envelope Monitor for CW and SSB Modulation Analysis
Carrera Bluetooth Race Controller Project
Operating StarLink Mobile Project
4 Channel WIFI Remote Relay Controller
4 Port High Power Remote Antenna Selector
Touch controller for Antenna selectors
Raspberry PI 5 Based AllStar “Radio”
Remote Stepper Motor Controller for Alpha Delta Switch
Two port remote antenna and rotor disconnect
Kenwood Remote Control Head Project
Rallye Odometer and Computer Project
StarLink Mobile Project
IC-706 Control Head Mount for Kia
Multi remote control head project – 5 individual heads
SteppIR Antenna Disconnect Project
Original 4-pole Antenna Disconnect – still in service
Original Rotor Cable Disconnect – still in service
TDOA UHF/VHF Direction Finder for Foxhunts
Stepper Motor SB-220/SB-220 Remote tuner
IC-706 remote separation kits.
Remote separation kits from Icom are no longer available. I asked Jeff if he could design an interface using standard Ethernet cable. He came up with these and they worked perfectly! These became very popular and he’s sold hundreds of them on EBAY. I use them everywhere.